PRO-TECH EDGE BEADING BIT 5/16' X 5/8' RADIUS 5/32' 1/4' SHANK KP319031

PRO-TECH EDGE BEADING BIT 5/16' X 5/8' RADIUS 5/32' 1/4' SHANK KP319031Corner Bead Edge Beading Bit Carbide Tipped Use this router bit to produce three slightly different profiles An edge bead with or without a fillet and a full corner bead by altering the bit extension or rolling the workpiece between passes. The corner bead router bit is suitable for antique reproductions and restoration projects. Use it in a handheld or table mounted router. This router bit has a 6,35mm shank (shaft) that will fit most small or large

Corner Bead | Edge Beading Bit

Carbide Tipped

Use this router bit to produce three slightly different profiles...

•  An edge bead with or without a fillet
• and a full corner bead by altering the bit extension or rolling the workpiece between passes.
• The corner bead router bit is suitable for antique reproductions and restoration projects.
• Use it in a handheld or table-mounted router.

PRO-TECH router bits are manufactured in Taiwan.

Router Table Safety

Although most router bits are small, they can be potentially dangerous and should deserve your attention and respect.

1 Use push sticks or a push block to position your hands a safe distance from the router bit.

2 Use large-diameter bits only in a router table. Using bits over 25mm Ø (diameter) in a handheld router can possibly cause you to lose control of the tool and harm yourself or bystanders.

3 Always wear a dust mask as well as eye and hearing protection.

4 Take light cuts. Heavy cuts invite kickback. If necessary, move the fence closer to the bit or switch to a larger guide bearing/bush.

5 Use a featherboard (anti-kickback device) to support the workpiece against the router table and/or fence.

6 Never climb-cut. Always feed the stock from right to left. Against the rotation of the router bit. (see illustration)

7 Avoid routing small stock. Instead, rout a larger piece and cut it to size afterwards. If you absolutely have to profile a small piece, build an suitable jig or secure the workpiece.

8 Always use a guard. If the fence didn t come with a guard, make your own.

9 Never start the router with the bit in contact with the material.

10 Don t force the router bit or overload the router. Excessive heat is an enemy.

11 Secure/fasten the router in the base before starting/switch on the router.

12 Don t bottom out the bit in the collet or partially insert the bit. Instead, completely insert the bit, and then back off approximately 2 mm. At least ²/₃ 's of the router bit shank should be inside the collet.

13 Be sober and not under the influence of medicine that causes a lack of concentration

14 Tidy up your workshop to ensure the ability to move freely with enough room around the router table

Length of Shank: 32 mm
Replacement bearing: KP100 1-2